Prostart CT-3300 2003 Dakota

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=23858
Printed Date: May 05, 2025 at 5:57 AM

Topic: Prostart CT-3300 2003 Dakota

Posted By: hioctane
Subject: Prostart CT-3300 2003 Dakota
Date Posted: January 03, 2004 at 6:39 PM

I'm installing a Prostart CT-3300 remote starter on my truck and I have everything wired up but the module won't accept the transmitter. I've tried about 50 times so far and the remote won't program. I've already exchanged the module thinking it was that and I still have the same problem. Any advice would be appreciated. Thanks

Replies:

Posted By: lspker
Date Posted: January 03, 2004 at 8:26 PM

Is the anntenna plugged into the correct port on the brain? Did you use the right extention wire for the annt? Make sure the unit is not in valet mode when trying to program (turn on ingtion and tap program switch)

Posted By: draasch
Date Posted: January 03, 2004 at 8:33 PM

you may also have to do a rest and start over......or call tech support @ 1-866-698-5872

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: ck auto
Date Posted: January 03, 2004 at 11:20 PM

hi flash hoodpin make sure lights stay on at least 6 sec then key on off on off then press lock button twice

-------------
good luck
kirk

Posted By: hioctane
Date Posted: January 04, 2004 at 10:38 PM

Actually, it turns out that the antenna was defective. I tried a different antenna and everything worked right away and now works fine. Thank for the quick responses though!

Posted By: hioctane
Date Posted: January 05, 2004 at 11:51 PM

I've installed a remote starter on my 2003 Dakota and i'm looking for an easy way to bypass the sentry key system. I don't care if its bypassed all the time. Right now i just have the chip out of the spare key inside the steering column. is this fine or will it screw anything up?? thanks.

Posted By: ck auto
Date Posted: January 06, 2004 at 10:02 PM

hi take a relay pin 85 to out while running on rs pin 86 to 12v pin 30 to 22 guage wire wrap this wire around head of key 6 times secure to key go up to ing wrap 6 times around ing then back down to pin 87 on relay make sure all wires are secure and you have a bypass only when rs is on the key inside the steering collumn can cause problems in some vehicles

-------------
good luck
kirk