88 chev pickup, bulldog rs 82 remote starter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=23868
Printed Date: July 29, 2025 at 10:37 AM
Topic: 88 chev pickup, bulldog rs 82 remote starter
Posted By: dddieter
Subject: 88 chev pickup, bulldog rs 82 remote starter
Date Posted: January 03, 2004 at 8:57 PM
I'm having trouble with a bulldog model rs 82 remote starter. Idon't know which is the tach sensor wire from the coil. I have an 88 chev pickup full size 350 V8. The bulldog is grinding the starter after it starts the vehicle a couple of times then shutting the truck off. There is 2 sets of a red and white wire coming off the top off the coil. which one would be the correct on to use? Thank You!! ------------- David
Replies:
Posted By: ck auto
Date Posted: January 03, 2004 at 11:17 PM
hi should be PURPLE / white at distributor or ecm behind glovebox also look for white wire with connector taped just under aircleaner assembly
-------------
good luck
kirk
Posted By: 7t3vette
Date Posted: January 04, 2004 at 8:27 AM
Goto www.bulldogsecurity.com there was a wiring mistake in the manuals. I beleive they have the starter and accy wire reversed in manual. Check the site out and see if this is your problem. 7t3vette
Posted By: LittleBill
Date Posted: January 05, 2004 at 6:27 PM
dddieter, if u have the 82I bulldog from walmart, i also had problems, when u finally figure out ur tach wire,connect it and program the unit, lol the truck probably won't even start, unit will click on then shut off, i went through about 2 hours looking at the damn thing wondering why my starter was saying on with the car started, and wouldn't fire up in tach mode, lol wiring schematic is wrong on the install, i had to reverse the wires for the starter and the accossory wire, the 2 on top of the box reverse the plugs and should work flawless
Posted By: LittleBill
Date Posted: January 05, 2004 at 6:28 PM
lol vette where were u like a month ago
Posted By: Kwazyace
Date Posted: January 05, 2004 at 8:28 PM
dddieter I am having a similar problem with an 88 GMC Sierra- it does not shut down the truck, but I am getting that continuing squeal/grind after the truck starts. It also is now happening even with the key when I try to start it only after using the remote starter. I don't believe the tach wire will help because it does not have a problem turning over- it is after starting. Will the tach sensor help to release the solenoid? I have an email over to bulldog. I'll let you know what they reply.
|