i was wondering if anybody has had any experience with the prestige aps-996a alarm remote start
any problems i should know about before installing
no problems with the aps-996a
-------------
Tommy
-Clifford/Directed/Alpine-Audio & Security-
New York Installer
I have a 94 3000gt, and i am putting in a audiovox APS-996. Do I have to disable the factory alarm so they they both don't arm together. The stosk alarm is supposed to arm on lock and unarm with unlock, is the arm and disarm wire the one at the lock cylinder? I was thinking to cut the arm wire at the door locks to prevent the factory alarm from evr arming. If anybody has any ideas I would appreciate the help.
Make: Mitsubishi
Model: 3000GT
Year: 1993-94
This Database Was Last Updated On: 6/9/2003
Index #: 1274
Alarm
Constant 12 volts WHITE IGNITION SWITCH HARNESS
Ignition 12 volts BLACK/ WHITE IGNITION SWITCH HARNESS
Starter BLACK / YELLOW IGNITION SWITCH HARNESS
Dome Light RED / GREEN (-) UNDER DASH LIGHT OR PIN SWITCH
Trunk Pin Switch RED / GREEN (-) LUGGAGE COMPARTMENT LIGHT
Parking Lamp ORANGE / SILVER DOTS AT FUSE BOX
Power Lock BROWN / BLUE AT RELAY BEHIND #201
Power Unlock BROWN / WHITE DRIVER DASH
#201- See Negative Pulse Door Lock Diagram.
OEM Alarm Disarm LIGHT GREEN (-) DRIVER KICK PANEL *
Factory Disarm: Dark Blue/Dark Green Found At Door Jam In Boot Or Left Of Steering Column At Keyless Entry.
Remote Start
Tach Signal WHITE/ BLACK OR WHITE AT COIL OR TACH FILTER
Ignition #2 BLUE/BLACK IGNITION SWITCH HARNESS
Ignition #3 N/A
Accessory BLUE IGNITION SWITCH HARNESS
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light GREEN (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Light RED / BLUE (+) AT SWITCH ON TRANSAXLE
Rear Window Defrost N/A
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Would I be able to permanently disable the factory alarm if I cut the arm wire at the lock cylinder? The thing I'm confused about is that in draasch's post there is no arm wire,but there is a disarm wire, Is it the same wire to arm and disarm? or am I missing something.
thanks for the help