Clifford Smart Remote Start 3 locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24046
Printed Date: July 20, 2025 at 11:34 AM

Topic: Clifford Smart Remote Start 3 locks

Posted By: fordtech
Subject: Clifford Smart Remote Start 3 locks
Date Posted: January 06, 2004 at 2:56 PM

I'm installing a Central locking system in my car, and it uses a neg trigger single wire (purple to lock, blue to unlock or vice versa)

I'm not sure how to wire that up with the NC NO COM unlock....NC NO COM lock from the remote start.

any help would be greatly appreciated!

Brad

Replies:

Posted By: draasch
Date Posted: January 06, 2004 at 3:55 PM

what is the model number of the unit????

what is the brand of door locks????

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: fordtech
Date Posted: January 06, 2004 at 6:00 PM

I'm not sure what the model number is on the system, and the locks are from A1 electronics Mesa central locking system.

Posted By: sparkie
Date Posted: January 06, 2004 at 6:59 PM

If your system requires a ground pulse to lock and unlock wire your starter as such:
Lock common - ground; Lock normally open - Lock wire for power lock system. Normally closed - not used
Unlock common - ground; Unlock normally open - Unlock wire for power lock system; Unlock normally closed - not used.

-------------
sparky

Posted By: fordtech
Date Posted: January 06, 2004 at 11:29 PM

I figured it out. On the Smart Remote Start III I had an OEM disarm and OEM arm wire, (BLACK/ green and BLACK/ orange) Those are a pluse ground, which is what I needed. I have also figured out the NC, NO, COM wiring as well, if anyone needs info.

Thanks for everyones help!!

Brad

Print Page | Close Window