Print Page | Close Window

2002 chrysler voyager starter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24128
Printed Date: May 11, 2025 at 10:54 PM


Topic: 2002 chrysler voyager starter

Posted By: nkennedy
Subject: 2002 chrysler voyager starter
Date Posted: January 07, 2004 at 4:46 PM

Newbie!!! I am installing an audiovox remote starter for my wife.  I have already read the previous posts but her is my problem.  Coming from the remote start unit I have the following wires connected:

Starter Harness              |                    Vehicle

RED / White (Bat 1)                               Battery

Red (Bat 2)                                          Battery

Yellow (Start)                                       yellow

Blue (IGN 1)                                        pink/white

Green (IGN 2)                                     -------------

Purple (Acc)                                        -------------

-------------------                                     PURPLE / brown  (Second starter)

How do I tie in the second starter wire and to what wire. I already have the relay sitting in front of me?




Replies:

Posted By: BNLUIS
Date Posted: January 07, 2004 at 5:34 PM
posted_image

-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.



Posted By: nkennedy
Date Posted: January 07, 2004 at 6:16 PM

I have the AA-RS30CS Model. 

Is the PURPLE / brown wire just activated during start.

 Does the yellow starter wire go to the relay?  Do I leave the green IGN 1 wire loose?  Is the resistir supposed to be grounded from relay position #87? 

Just yell if I am a pain!

Thanks, Nick




Posted By: Velocity Motors
Date Posted: January 08, 2004 at 2:42 AM
The 2nd starter is only active during remote start just like the primary starter wire. The Starter wire does go to a relay  ( not sure where though ) Leave the GREEN and the PURPLE wires as they are not used for this vehicle. You have to add a relay for the 2nd starter wire as shown above and the resistor goes on pin 30 and pin 87 is to ground. When the relay is activated , pin 30 and 87 connect sending a ground signal with a 180 ohm signal to the 2nd starter wire.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: nkennedy
Date Posted: January 08, 2004 at 10:32 AM

Thank you, that clears a lot of things up!

Nick


Print Page | Close Window