95 Explorer remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24196
Printed Date: May 16, 2025 at 6:38 PM
Topic: 95 Explorer remote start
Posted By: golfnut64
Subject: 95 Explorer remote start
Date Posted: January 08, 2004 at 4:24 PM
I have a 95 Ford Explorer trying to install a RS on It has 2 GREEN/ purple ign wires & 2 gray / YELLOW wires .Design Tech wire guide says Ign 1 is light GREEN/ purple Ign 2 gray / YELLOW Ign 3 gray / YELLOW Acc BLACK/ light green The problem i have is it will start & run for 30sec. in tach or tackless mode. It will continue to run if i apply 12 volts to the 2nd GREEN/ purple wires I think the wire colors given are wrong ?? Please help LB
-------------
Lloyd
Replies:
Posted By: ossrom
Date Posted: January 08, 2004 at 9:02 PM
your alarm should have heavy wires marked in the manual as ignition1, ignition2, acc, in some aarmas there will be a wire marked as ignition3.....in any case the GREEN/ purple wire goes to the ignition1 wire,(you only need to conect it to one of the GREEN/ purple wires). the grey / YELLOW wires are ignition2 and ignition3 (you may need to use an extra relay)and your BLACK/ lightgreen wire is your accessories
Posted By: golfnut64
Date Posted: January 11, 2004 at 6:23 AM
Thanks a lot after spending many hours on this i found the remote starter was bad , Tryed a different unit & it worked fine , has anyone seen this problem before & know what causes it ? Thanks again LB
-------------
Lloyd
|