98 Accord EX factory alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24229
Printed Date: May 13, 2024 at 7:32 PM

Topic: 98 Accord EX factory alarm

Posted By: dakest
Subject: 98 Accord EX factory alarm
Date Posted: January 08, 2004 at 11:37 PM

This my first time here, I need to know how to add a starter kill, a glass/shock sensor and a siren instead of the horn in a 98 Accord EX V6 factory alarm.

I like to know where the module is and the wires coming out of it.

Thanks!!

Replies:

Posted By: evolutionoftym
Date Posted: January 09, 2004 at 12:56 AM

it should be in the upper left hand side of the drivers side dash just above the DKP....

-------------

Posted By: dakest
Date Posted: January 09, 2004 at 2:06 AM

I appreciate it, really, Is what I am trying to do could be done? or should I be better off with a aftermarket unit.

I have a Crime Guard 533i ,are they decent? and do you know the colors of the wires coming from the module and what they do?

damn!!! I am asking to many question too fast, sorry

Posted By: dakest
Date Posted: January 12, 2004 at 3:44 PM

Anybody wants to help? I can' find the alarm module, what does it look like, can it be disabled?

I would reeeally appreciated pleeease!

Posted By: dakest
Date Posted: January 13, 2004 at 12:07 AM

I am trying to find the factory alarm module in my 98 Accord EX V6 and the pinout or wire color/id coming from the module.

Please!! thanks in advance.

Posted By: serialthrlla
Date Posted: January 13, 2004 at 12:53 AM

on the ex models the fact. alarm arms and disarms with the locks. I would just add an aftermarket and call it a day. I imagine bypassing the factory system would be difficult

Posted By: draasch
Date Posted: January 13, 2004 at 6:03 AM

if you are hooking up an alarm try this info:

Make:   Honda
Model: Accord
Year:    1998
This Database Was Last Updated On:    6/9/2003
Index #: 5620

Alarm
Constant 12 volts WHITE IGNITION SWITCH HARNESS
Ignition 12 volts BLACK / YELLOW IGNITION SWITCH HARNESS
Starter BLACK/ WHITE IGNITION SWITCH HARNESS *
Dome Light BLACK/ WHITE (-) 4 PIN GREEN CONN. IN PASS. FUSE BOX
Trunk Pin Switch ORANGE (-) 18 PIN GRAY CONN. IN DR. KICK PANEL
Parking Lamp RED / BLACK (+) AT FUSE BLOCK ON DRIVERS SIDE
Power Lock BLACK/ WHITE 2 PIN GRAY CONNECTOR #201
Power Unlock GREEN/ RED IN DRIVER KICK PANEL(SEE TECH ON EX)

* Installing A Starter Kill Relay At The Ignition Switch Harness Before The Starter Wire Enters The Driver Side Fuse Block May Cause A "Check Engine" Light To Come On. Starter Wire Should Be Accessed After Fuse Block. #201 - See Negative Pulse Door Lock Diagram.

Remote Start
Tach Signal BLUE AT TACH TEST CONNECTOR * #239
Ignition #2 YELLOW IGNITION SWITCH HARNESS
Ignition #3 N/A
Accessory WHITE/ BLACK IGNITION SWITCH HARNESS
Neutral Safety BLUE/WHITE (-) AT POWERTRAIN CONTROL MODULE **
Brake Light WHITE/ BLACK (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Light GREEN/ BLACK (+) AT FUSE BLOCK ON BEHIND DRIVERS DASH
Rear Window Defrost N/A

* 4 Cylinder Tach Test Connector (2 Pin White Connector) Is Located On Pass. Side Of Engine Compartment Next To Battery. 6 Cylinder Tach Test Connector (2 Pin White Connector) Is Located On Dr Rear Of Engine Compartment. ** Powertrain Control Module Is Located Behind The Right Side Of The Center Console Behind The Passenger Dash. #239 - See Immobilizer Bypass Diagram See Tech Notes!!!

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt