Print Page | Close Window

98 cavalier bulb test wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24315
Printed Date: May 27, 2025 at 2:03 PM


Topic: 98 cavalier bulb test wire

Posted By: harvest honda
Subject: 98 cavalier bulb test wire
Date Posted: January 10, 2004 at 1:19 PM

I need to know the wire color and location of the bulb test wire. Any help would be very appreciated. 




Replies:

Posted By: draasch
Date Posted: January 10, 2004 at 1:29 PM
not sure i know what your talking about...are you talking about the dome light???


Make:   Chevrolet
Model: Cavalier
Year:    1998
This Database Was Last Updated On:    6/9/2003
Index #: 9268


Alarm
Constant 12 volts RED & RED IGNITION SWITCH HARNESS
Ignition 12 volts PINK IGNITION SWITCH HARNESS
Starter YELLOW IGNITION SWITCH HARNESS
Dome Light L GREEN/ BLACK (DR) & L BLUE (ALL DOORS) AT CONV. CENTER *
Trunk Pin Switch N/A
Parking Lamp BROWN (+) AT HEADLIGHT SWITCH
Power Lock L BLUE DRIVER KICK (W/O OEM KEYLESS) ** #203
Power Unlock WHITE PANEL (W/OEM KEYLESS) #202

* L GREEN/ BLACK (-) Covers Driver Door Only. L BLUE (-) Covers All Other Doors. Diode Isolation Needed, Cathode (Band) Side Of Diode Faces OEM Wires. Convenience Center Module Located Above Passenger Kick Panel. ** Without OEM Keyless Door Lock Wires MUST Be Tested From PASSENGER Switch!! W/O OEM Keyless See Note #203 Reversal Rest At Ground Door Lock Diagram. With OEM Keyless See Note #202 Positive Pulse Door Lock Diagram.


-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt





Posted By: harvest honda
Date Posted: January 10, 2004 at 1:40 PM

No, the vehicle bulb test wire required for the passlock 1 bypass.





Posted By: sparkie
Date Posted: January 10, 2004 at 4:57 PM
The bulb test wire in your car is the small black wire in one of the plugs going into your ignition switch. There are twoo small black wires in one plug and one in the other plug. This lone black wire is the bulb test wire. It will go to ground during crank.

-------------
sparky




Posted By: jrilla
Date Posted: January 10, 2004 at 5:49 PM
yeah I think it is in the same plug as the Red power wires if i remeber correctly.

-------------
J Rilla

Owner/Installer




Posted By: Alpine Guy
Date Posted: January 10, 2004 at 6:29 PM
yes, it is in the black 5 way connector....the one on the top.  It has your constant power wire in that plug.





Print Page | Close Window