Smart Car Wiring, Mannix

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24514
Printed Date: May 20, 2024 at 7:52 AM

Topic: Smart Car Wiring, Mannix

Posted By: nitram
Subject: Smart Car Wiring, Mannix
Date Posted: January 13, 2004 at 12:55 PM

Do any of you kind people have a Wiring Diagram for this car?

I can figure out the connections myself but I would appreciate a diagram to save me some time.

Regards Nitram London UK

Replies:

Posted By: nitram
Date Posted: January 13, 2004 at 1:49 PM

Does anyone have the connections for this car?

In particular I am trying to connect the Start/kill and Anti-jack relays without removing the IGN housing to find out the connections.

Regards Nitram London UK

Posted By: nitram
Date Posted: January 20, 2004 at 1:06 PM

I have bought this alarm and it has an led output + & - for a standard flashing LED.

I want to install a DEI window Led and although it comes with a two wire connection. It says to connect to Red to +12 constant, black wire to - armed output, orange wire of the security system.

Why is this? is it a power issue or a flashing one? ( it has a seperate module attached, for flash?)

Also am I correct that this should be connected to the Orange Start Kill wire?

Can the module be cut off and just attached directly to the led output?

Sorry for so many questions, but I do n't want to destroy anything!

Regards Nitram UK

Posted By: nitram
Date Posted: January 21, 2004 at 12:28 PM

I have found the two negative wires for my smart car and have connected them directly to the Alarm.

According to Techsoft read-out they are Green and Blue, behind the fusebox. I confirmed them with a test light.

I connected the Blue from the Mannix to the Blue wire on the car plus connected the other two together.

Unfortunately the Alarm does not Lock or unlock when arming/disarming.

Do you think that I have my wires crossed over?

Will changing them around cause any problems?

Posted By: nitram
Date Posted: January 21, 2004 at 1:12 PM

Can anyone tell me the correct colour of the dash input (not ribbon tach output) so I can connect my Alarm to it?

Regards Nitram

Posted By: Javelin3o4
Date Posted: January 21, 2004 at 2:25 PM

you can try switching them around, or see if maybe it needs a double pulse signal from the alarm to lock/unlock

Posted By: abright52
Date Posted: January 21, 2004 at 3:13 PM

-

-------------