Black Widow BW7150 on 01’ Galant

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24532
Printed Date: July 21, 2025 at 9:48 PM

Topic: Black Widow BW7150 on 01’ Galant

Posted By: pr8gg
Subject: Black Widow BW7150 on 01’ Galant
Date Posted: January 13, 2004 at 7:38 PM

I just install this alarm/remote start, I already notice that this particular brand is not very welcome here, but I am not a pro to this field, I have had 3 other of them in the past, without any type of problem, but now, I think I have:

First: it wont start, it cranks the 3 times, but nothing, I connect all as the wiring schedules, the tach wire, the brake wire, the transponder, but even leaving a key in the ignition, no luck.

Second: I have try to program the alarm, but it wont let me.

and finally: I notice that the led lights up when I drive the car over any bump(shock sensor?), or if I hit the brakes.

anything else works, the trunk, the door locks, the alarm arm, disarm, sence shocks

please advise?

Replies:

Posted By: Teamrf
Date Posted: January 14, 2004 at 12:42 AM

Check your voltage on your heavy gauge wires during remote start. Check all connections. If you used T-Taps or just black tape you may have some wires that have come apart. Also make sure you have that transponder wired up correctly.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.

Posted By: jrilla
Date Posted: January 14, 2004 at 10:01 AM

Make sure you dont have the ignition and accessory outputs from the alarm reversed. I am pretty sure they can be reversed on the unit, but maybe you installed them on the wrong factory wire.

-------------
J Rilla

Owner/Installer