2002 dodge neon remote start install
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24542
Printed Date: July 23, 2025 at 11:14 AM
Topic: 2002 dodge neon remote start install
Posted By: bhouse1587
Subject: 2002 dodge neon remote start install
Date Posted: January 13, 2004 at 10:37 PM
i have installed all wires with the bypass kit (it is the grey key) and it just clicks it wont start and i dont know why i have installed starters before and didnt have a problem could someone help me they both are bulldog security (starter, and bypass kit) could it be a bad starter or bypass please give help. and what is this i hear about the resistor to unlock the doors im confused with that thanks guys...
Tim
Replies:
Posted By: tjdurham
Date Posted: January 13, 2004 at 11:14 PM
you will need resistors to do door locks and factory disarm try putting a key in the ignition not turning it on and see if it starts if it does check your bypass not familliar with bulldog havent installed them since 95 (lost alot of $$$on them)
-------------
tj
Posted By: bhouse1587
Date Posted: January 13, 2004 at 11:20 PM
ive done that it just doesnt want to start. i havnt put the door locks in because it really confused me but i think i might take both back and get new ones (just the modules) becaues i installed this same one on my car and i didnt have a problem at all. so i think it might be the modules are bad but any other suggestions? i cant get it to work.. thanks
Posted By: bhouse1587
Date Posted: January 14, 2004 at 11:18 PM
does anyone have any other suggestions???
Posted By: Alpine Guy
Date Posted: January 15, 2004 at 8:17 PM
if it has a factory alarm, that may be whats stopping it from starting. You will need to hook up the disarm wire.
Posted By: tomberndt
Date Posted: January 15, 2004 at 11:11 PM
check your tach signal, or are you RS by voltage type? Factory disarm shouldn't be making the vehicle not start.
Posted By: Velocity Motors
Date Posted: January 15, 2004 at 11:16 PM
Did you use a starter disable relay in your installation ? If so make sure that the starter wire from the remote start unit is attached on the MOTOR side of the relay and not on the SWITCH side.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|