1991 Lincoln Continental Door Locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24705
Printed Date: August 01, 2025 at 9:54 PM

Topic: 1991 Lincoln Continental Door Locks

Posted By: djmode
Subject: 1991 Lincoln Continental Door Locks
Date Posted: January 16, 2004 at 1:19 PM

I am installing a Remote Starter in a 91 Lincoln Continental and can't seem to figure out the door locks. Does anyone know how to hook up the control module's 500mA lock output wire to the door locks? Will I need any relays? The instructions say that the wire goes to a door lock module (which I don't have), but I'm hoping I can do the same thing with relays. Thanks to anyone who can help me out... it is really appreciated...

It is a JTI A-19 Stand Alone Starter... if that helps.

Thanks...

Replies:

Posted By: jrilla
Date Posted: January 16, 2004 at 4:25 PM

Lock is Pink / YELLOW
Unlock is Pink/Green

You need to cut the factory wires and install the relays as shown.

Set it up like this:

posted_image

-------------
J Rilla

Owner/Installer

Posted By: djmode
Date Posted: January 16, 2004 at 5:12 PM

Thanks.... cool diagram, but it shows two outputs from the alarm, a (-) unlock and a (-) lock. While the JTI remote starter that I have only has one combined door lock/unlock wire ( -500mA), and I can only assume maybe its pulsed (once for lock, twice for unlock ?? ) It says this wire is supposed to go to a "DM 600 lock module". Can I wire up the relays with the single output wire or do I need that module? Thanks again...

Posted By: Velocity Motors
Date Posted: January 16, 2004 at 5:29 PM

No you can't, you will need to purchase the DM 600 lock module in order for you to get two individual lock and unlock pulses.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: djmode
Date Posted: January 16, 2004 at 5:51 PM

Thanks for your help with this. I really appreciate it. Does anyone know a good place where I could get that module (or something similar)???

Posted By: prdjr165
Date Posted: January 18, 2004 at 2:00 PM

how did you get the car to run?I tried putting a r/s uniy in a 91 towncar and it gave me nothing but problems.it would start and then shut down right away.

Posted By: Velocity Motors
Date Posted: January 18, 2004 at 2:12 PM

djmode wrote:

Thanks for your help with this. I really appreciate it. Does anyone know a good place where I could get that module (or something similar)???

Try eBay , usually you can find some of these modules on there.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA