dei valet remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=24842
Printed Date: August 27, 2025 at 10:51 AM
Topic: dei valet remote start
Posted By: smarshall80
Subject: dei valet remote start
Date Posted: January 18, 2004 at 9:29 PM
I just installed a dei remote start on a 97 ford f150. its just a straight remote starter. it dosent start on the first try when the engine is completly cold. which doesnt surprise me because the starter is the fact original and im sure it needs replaced soon. It almost always will start on the second start, but when it starts it runs for about 15 sec then shuts off. It starts right up of course when the trucks been ran or its warm out. the system is set to run off the tach. Im a very new installer and im sure this is a rookie problem so please help me get better!!!! Should i set it to run off of voltage? and set it to low voltage??? any help would be apprecated. oh yah, i had to turn the crank time to 1.2 if that is important.
Replies:
Posted By: JWorm
Date Posted: January 18, 2004 at 9:53 PM
Changing the crank time has no effect unless you are on voltage sense. Did you use the WHITE/ pink wire for tach? Using an injector on those trucks usually gives problems with a DEI system.
Posted By: Teken
Date Posted: January 18, 2004 at 10:13 PM
I would suggest that you take care of the basics of the starting system first. No matter how good your RS is, or how well it is installed.
If the basics are not there, the vehicle will never RS consistantly.
Give the vehicle a tune up. Have a AVR test done to the electrical system.
A tired battery, spark plugs, cap, rotor, ignition wires, and so on. All affect starting, and reliability of the vehicle.
Take care of the basics, and the rest will fall into place.
Regards
EVIL Teken . . .
Posted By: smarshall80
Date Posted: January 19, 2004 at 12:39 AM
hey yah, the wire on my system for the tach is purple with a white line on it.... oh yah teken, this is my truck, i actually have put a new battery, plugs wires and a new coil pack on it. so im not sure what to do now
Posted By: profuse007
Date Posted: January 19, 2004 at 3:23 AM
its prolly ur cold start injector. if ur car start and able to idle its not any of those ignition components.
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: JWorm
Date Posted: January 19, 2004 at 10:31 AM
"hey yah, the wire on my system for the tach is purple with a white line on it"
I know what color wire on the remote start system the tach wire is, I was referring to what wire you used on the truck for tach.
Posted By: mobiletoys2002
Date Posted: January 19, 2004 at 11:06 AM
the WHITE/ pink tach wire is located at the pcm in the engine bay. the pcm is on the passenger side firewall it has one big harness facing the front of the car . If i remember right there was more than one WHITE/ pink wire so test to verify the correct one. After that reprogram the tach using the valet switch and see what happens.
|