Print Page | Close Window

Wiring Diagram for 04 Acura TL ?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25317
Printed Date: June 09, 2024 at 7:48 AM


Topic: Wiring Diagram for 04 Acura TL ?

Posted By: TrueSound
Subject: Wiring Diagram for 04 Acura TL ?
Date Posted: January 26, 2004 at 6:41 PM

Does anyone have the info for the 04 TL? Doing an alarm remote start keyless on it. I'm hoping it's somewhat like the 04 Accord. . . . .

Thanks in advance




Replies:

Posted By: bmf1000d
Date Posted: January 26, 2004 at 6:52 PM
WIRE COLORSLOCATION
12 VOLTS CONSTANTWHITEIGNITION SWITCH HARNESS
IGNITION 1BLACK / YELLOWIGNITION SWITCH HARNESS
IGNITION 2YELLOWIGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER WHITE/ BLACKIGNITION SWITCH HARNESS
STARTERBLACK/ WHITE IGNITION SWITCH HARNESS
KEYSENSERED / WHITE or     RED / BLACK ( - )IGNITION SWITCH HARNESS
PARKING LIGHTS ( + )RED / BLACK LARGE WHITE PLUG ABOVE FUSE BOX
DOMELIGHTGREEN/ RED ( - )GREEN 5 PIN PLUG BEHIND THE FUSE BOX
POWER DOOR LOCKPINK/BLACK ( - )IN GREEN PLUG LEFT SIDE OF  FUSE BOX
POWER DOOR UNLOCKPINK/BLUE  ( - ) (TYPE B)     *SEE NOTES* 1
TRUNK RELEASEYELLOW /GREEN ( + )DRIVER KICK PANEL HARNESS TO REAR
TACH SENSORBLUE/RED or BLUE  (AC)AT THE ECM/PCM *SEE NOTES*  2
BRAKEWHITE/ BLACK ( + )AT THE BRAKE PEDAL SWITCH
HORNGREEN/ YELLOW ( - )AT THE STEERING COLUMN
FACTORY DISARMWHITE   ( - )DRIVER DOOR MODULE IN DOOR
FACTORY ANTI-THEFTTYPETRANSPONDER
NOTES:

*1 - These wires will meter using the passenger door  lock switch.

*2 - The ECM/PCM is on the front of the transmission tunnel. The connectors are on the passenger side. On the 4 cylinder models the tach wire is in the WHITE 31 pin connector E, pin 25.  On the 6 cylinder models it is in the GRAY connector A, pin 23.



-------------
"Big" Mike
Double Take
Fremont, Ne
remember to check all your wires with a dmm not a test light!!
i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof




Posted By: TrueSound
Date Posted: January 27, 2004 at 3:36 PM

Good looking out!!  Double Take

 If anyone has done one, and has some time savers please reply. . . . .






Print Page | Close Window