95 gmc remote start tranny no shift

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25324
Printed Date: May 19, 2024 at 10:06 AM

Topic: 95 gmc remote start tranny no shift

Posted By: chopdaddy
Subject: 95 gmc remote start tranny no shift
Date Posted: January 26, 2004 at 8:16 PM

i installed an extreme remote start in my 1995 gmc K2500 and about 1 in every 10 times i use it the tranny will not shift out of 2nd gear. it is only an intermittent problem and i am pretty sure all the wires are connected correctly. anybody else have this problem? please respond.

Replies:

Posted By: murraymurray
Date Posted: January 26, 2004 at 8:58 PM

Did you hook up the secound ignition wire it is a white wire which needs to be hooked ou with either a secound relay or a secondary ignition output from the remote starter which ever you have for the remote starter you put in.

Murraymurray

-------------
murraywatchel

Posted By: chopdaddy
Date Posted: January 28, 2004 at 6:52 PM

thanks for the reply. yes the second ignition wire is connected up the the remote correctly. any other suggestions. please reply.

Posted By: HamiltonAudio
Date Posted: January 28, 2004 at 7:20 PM

is the remote start intermittently not powering up the second ignition wire? this is the classic symptom....

Posted By: sroth140
Date Posted: January 29, 2004 at 12:18 AM

we just had a 93 blazer do the same thing except it would not shift at all and the speedo. we checked the fuses and there was one blown in the cab. i doubt something is blown if yours is intermittent... but maybe you have a bad solder joint on the ign wires.

Posted By: HamiltonAudio
Date Posted: January 29, 2004 at 7:34 AM

agree, perhaps a completely cold solder joint on the second ignition????

Print Page | Close Window