Tach wire is damaged on Honda accord 1998
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25356
Printed Date: June 10, 2024 at 2:49 PM
Topic: Tach wire is damaged on Honda accord 1998
Posted By: nguyen
Subject: Tach wire is damaged on Honda accord 1998
Date Posted: January 27, 2004 at 11:13 AM
I test a tach wire on Honda accord 1998, show 4-5volt AC when engine run. It is blue wire at 2pin test connector near the battery.
Some how after 5 minute volt meter show o volt when engine run or stop. When I start a car by key the light "require maintains" is plashing, the remote commando 5005 can’t learn this tach wire
What should I do if A tach wire is damaged ?
Nguyen
Replies:
Posted By: boomer_106
Date Posted: January 27, 2004 at 3:01 PM
Remote Starter Wiring Colors and Notes | Function | | Vehicle Color | Location | Start: | | BLACK/ WHITE | IGNITION SWITCH HARNESS ** | Ignition #1: | | BLACK / YELLOW | IGNITION SWITCH HARNESS | Ignition #2: | | YELLOW | IGNITION SWITCH HARNESS | Ignition #3: | | | | Accessory: | | WHITE/ BLACK | IGNITION SWITCH HARNESS | Brake Light: | | WHITE/ BLACK | AT SWITCH ABOVE BRAKE PEDAL | Tach Signal: | | BLUE | AT COIL MODULE | Parking Lights: | | RED / BLACK | AT FUSE BLOCK ON DRIVER'S SIDE | Headlights: | | | | OEM Alarm Disarm: | | BLUE | INSIDE OF DRIVER'S DOOR | OEM Alarm Arm: | | BLUE/WHITE | INSIDE OF DRIVER'S DOOR | Diesel Glow Plug: | | | | Clutch Bypass Wire: | | | | Notes: | | * This vehicle is equipped with a transponder immobilizer system; See Installation Note #144 - Bypassing Transponder Theft Systems. |
Posted By: Teamrf
Date Posted: January 28, 2004 at 12:09 AM
Well I'm not too sure about those alarms but if it has a "voltage sense" you can just program it to start from voltage. A lot of installers use voltage in the first place.
-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.
Posted By: jimmeezgolfvr6
Date Posted: January 28, 2004 at 5:45 AM
a good alternative is using one of the fuel injector wires. each fuel injector should have 2 wires to it, and there will be a same coloured wire amongst all of them....use one of the wires that is different coloured.
good luck
Posted By: daniel2002p
Date Posted: January 29, 2004 at 9:11 PM
go with the odd coloured wire at the injectors.
-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!
|