Print Page | Close Window

Programming mode commando 2020 alarm syst

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25629
Printed Date: May 16, 2025 at 4:09 AM


Topic: Programming mode commando 2020 alarm syst

Posted By: grayfoxx
Subject: Programming mode commando 2020 alarm syst
Date Posted: January 31, 2004 at 3:25 PM

I have installed a commando 2020 car alarm into my 1967 MGB Roadster that has a positive ground system.  At this time I only have the motion sensor hooked up.   This car does not have power locks or need trunk release.  I only wanted to use the motion sensor.  The problem I am having is that after disarming the unit 30 sec later it rearms.  I didn't run the wire to the ignition input as this is a positive ground electrical syatem. 

How do I get into the programming mode to change passive arming to active arming so it will only arm when the remote is pushed?



-------------
Thanks,
Grayfoxx



Replies:

Posted By: jrilla
Date Posted: January 31, 2004 at 9:43 PM
No manual came with it? I cant find that unit online anywhere that has a manual. asianwolf.com has it for sale though I bet they would let you know if you emailed them.

-------------
J Rilla

Owner/Installer


Print Page | Close Window