cavallier anti theft problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25769
Printed Date: June 09, 2024 at 12:55 AM
Topic: cavallier anti theft problem
Posted By: dr.thunder
Subject: cavallier anti theft problem
Date Posted: February 03, 2004 at 8:38 AM
Hello, I have a 98 cavallier and am installing a CS2011rs series iv with a Omega db-pl2002. I am having a problem determining wich wires i need to tap for the factory anti-theft bypass and wich install diagram to use. as of now it is all wired but the car will only start by the remote every once in a while, usually immediately after it is started with the key. thanks in advance.
Replies:
Posted By: sroth140
Date Posted: February 03, 2004 at 11:00 AM
you have to bypass the passlock system. go to directed.com and look under installation manuals for part number 555L. the wires are located in the bottom of the shroud covering the streeing wheel shaft into the dash. if you have tilt on the steering wheel its really fun to take off :(
Posted By: lspker
Date Posted: February 03, 2004 at 8:15 PM
The car is a passlock 1 set up, make sure you hook up the bulb test wire. Sometimes you may need to try a few bypass mods, some cars are very picky on which units work, and then may work 9 out of ten times. When they work, they work well.
Posted By: jrilla
Date Posted: February 03, 2004 at 9:37 PM
Use diagram 3 on this page if you have any troubles with a bypass module. I had trouble with Cavaliers w/ passlock I awhile back so I made up this diagram and it works wundyflee.
Passlock I temporary bypass------------- J Rilla
Owner/Installer
|