hesitant to use my PKF Ver. 4.05

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25868
Printed Date: July 07, 2025 at 5:01 PM

Topic: hesitant to use my PKF Ver. 4.05

Posted By: repair
Subject: hesitant to use my PKF Ver. 4.05
Date Posted: February 04, 2004 at 9:38 PM

I have a been running my remote start with a key under the plastic close to the baril for the last while, because I am scared of dying out on the road because of my pkf bypass cut ignition wire to baril. I have and an output from control unit of remote start that goes to ground when my truck is running by remote start only. Not when truck is run by key.

Will this work for my truck it seams like this delay to ground till after the truck has started will have it act like no key at all and not start.

Somebody give me the needed push I need to install this thing by saying it will work or it should work.

Replies:

Posted By: extreme1
Date Posted: February 05, 2004 at 4:13 PM

PKF's work flawlessly, I've installed about 100 over the last year, none have had problems.

Posted By: repair
Date Posted: February 05, 2004 at 7:11 PM

Thank you that is what I needed to hear, I will give this thing a try. I hope those 100 PKF you installed were like mine with the cut ignition wire to the baril. The other forum on the PKF install had a crimestopper model that this is reattached after. Wish mine was like that.

Yes Jeff I will leave a donation if this thing works