Toyota disarm wire
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=25937
Printed Date: July 22, 2025 at 6:10 PM
Topic: Toyota disarm wire
Posted By: MikeHusain
Subject: Toyota disarm wire
Date Posted: February 06, 2004 at 8:39 AM
I was wondering if anyone new what the disarm wire is for a 2000 4 runner and where it is located. My rs only has a constant ground output while running, not a pulse. Could I use that constant output or do i need to convert the constant to a pulse output using a relay? Thanks, ...
Replies:
Posted By: jrilla
Date Posted: February 06, 2004 at 8:53 AM
The 4 runner disarms with the unlock wire, and the RS will not trigger the alarm during a remote start sequence, so you dont need to disarm the alarm other than with the unlock wire.
You have 2 unlock wires just so you know.
-------------
J Rilla
Owner/Installer
Posted By: MikeHusain
Date Posted: February 08, 2004 at 9:35 PM
The reason why i needed that disarm wire is becaues sometimes when the rs is activated, the factory alarm goes off, any suggestions? Thanks
Posted By: mobiletoys2002
Date Posted: February 08, 2004 at 9:44 PM
use the yellow/red at the ignition harness this will be the key sense wire if you ground it while remote start factory will never go off!!!! also known as disarm no unlock !
Posted By: MikeHusain
Date Posted: February 09, 2004 at 10:00 AM
Much thanks
|