Print Page | Close Window

New remote start Heater recycle problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=26371
Printed Date: July 18, 2025 at 8:30 PM


Topic: New remote start Heater recycle problem

Posted By: pritch55
Subject: New remote start Heater recycle problem
Date Posted: February 12, 2004 at 8:49 PM

 I just had a Clifford 3.5 remote start alarm installed and now I'm having problems with my AC/Heater unit. No matter what setting I have it on the recycle selection will automatically turn on about 30 seconds after the truck has been started. When I change from defrost to vent or the floor it will turn off but then comes back on 30 seconds later. If I try and turn the recycle on it will blink to let me know that I can't use this, but then it will automatically turn itself on. When I try and turn it off it blinks to let me know that I can't do that. I went back to the place where I had this installed and they have no clue what could cause this. I'm going to go back tomorrow to talk to the guy who installed it but after that the only option I can think of is the Dealer? Any help would be greatly appreciated.

Here are a couple links to some small clips.

https://home.mn.rr.com/bpritchard/images/MOV00819.MPG

https://home.mn.rr.com/bpritchard/images/MOV00820.MPG

Thanks,
-Pritch55




Replies:

Posted By: sroth140
Date Posted: February 12, 2004 at 10:28 PM
what kind of vehicle is it?  it might be something simple like not powering up the right (or all of) the accy wires.  also, was anything like rear defogger hooked up on any extra channels?  and finally, does it do that when started with the key, or just on remote start, or always?


Print Page | Close Window