01Explorer Sport Keyless Entry

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=26576
Printed Date: July 14, 2025 at 4:21 AM

Topic: 01Explorer Sport Keyless Entry

Posted By: mmoe
Subject: 01Explorer Sport Keyless Entry
Date Posted: February 16, 2004 at 12:41 PM

I am installing an Audiovox AA-925 in a 01 Explorer Sport and i am having difficulties getting the relays to work for the door locks i know that the wire in the kick panel are pink / YELLOW pink/green. Can some one help

Replies:

Posted By: draasch
Date Posted: February 16, 2004 at 1:29 PM

is this a sport trac??? or just a sport

Ford

Explorer

1997-2001

Power Lock:
   PINK / YELLOW
DRIVER KICK PANEL *****

Power Unlock:
   PINK/L GREEN
DRIVER KICK PANEL *****

Ford

Explorer Sport Trac

2001
Power Lock:
   Pink / YELLOW
Driver's Kick Panel***

Power Unlock:
   Pink/Lt. Green
Driver's Kick Panel***

*** If Equipped With Factory Keyless Entry, See Note #201 - Negative Pulse Door Lock Diagram. Without Keyless Entry, See Note #203 - Reverse Polarity Door Lock Diagram

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: kgerry
Date Posted: February 16, 2004 at 1:59 PM

Cut one of the 2 door lock wires...if you lose both functions you have a reverse polarity system and need relays or a DRL module...if you cut one wire and you only lose that one feature then its a wire tie in assuming the unit you're installing has dual polarity DRL outputs.

Posted By: mmoe
Date Posted: February 16, 2004 at 11:41 PM

Its just a Sport. And now the problem i am having is that when i cut the wire lets say to the lock when i go to the passenger door i can lock the doors but i cant unlock. And Vice Versa. But my driver side door doesnt work at all. now when i hook up my relays i hook up pin 87 and 86 to 12v then i hook pin 85 to the module's output. NOw when i hook up the lock side to the 87a middle pin i blow a fuse. if i hook up just the motor leg to pin 30 then when i press lock then it locks the doors but i still have no control from the driver side door. If i hook up.both ends to pin 30 then when i lock the doors it locks but blows a fuse. What am i doing wrong?