2 Sirens, Horn, Setup Problems

OK, I have a Clifford RSX 3.5, and i have the siren with a PIezo siren inside of the car to a relay, I want to connect the Horn too, But I did but when the alarm is trigger i get constan Pulse so It does not sound good, the alarm setting you can change either pulse or constant, but when I put it in Pulse the horn sound good but inside of the car you can even feel the piezo siren and the siren itsself... So What I did i Connect it to a relay that goes to the Parking lights but when i ppree the arm in the remote It sound TOOO HARD,,, That everybofdy can hear it, SO I want to make it work with the siren constant and the horn pulse.. I dont know if adding a Flasher could work and how??/

thank you

ok you have the relay with the pezio and siren hook up to the brown siren output wire right?

-------------
"Big" Mike
Double Take
Fremont, Ne
remember to check all your wires with a dmm not a test light!!
i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof

yes

o.k., you will need two more relays to hook up your horn.

relay # 1

86& 87 go to fused 12v constant

85 goes to the orange wire from the 3.5x (ground when armed)

30 goes to relay # 2's 86

(the rest of relay#2)

87 goes to (-) if the horn is negative trigger/goes to (+) if the horn is positive trigger.( make sure you verify this with your dmm. )

30 goes to the horn trigger wire of the vehicle

85 goes to the BLACK/ white from the 3.5x (this is the domelight supervision wire and will provide your pulsed output for the horn to honk.)

good luck and have fun.

-------------
do it right the first time....less warranty work=more money!:)

ok, I will try doing it today.


The horn have a + trigger

also, if you have any other security components (window mods, motion sensor, digital tilt sensor, ect.) make sure you diode isolate each component from one another to prevent backfeeding and undesired operation.

 also, if you arm the vehicle, then remote start the vehicle, then disarm the vehicle to get in, and the horn starts to go off constant (not pulsed) then go to the program menu (in the install guide) and program OFF the ant-grind .

-------------
do it right the first time....less warranty work=more money!:)

ok