Print Page | Close Window

This Thing Is Driving Me Crazy

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=2696
Printed Date: May 28, 2024 at 1:51 PM


Topic: This Thing Is Driving Me Crazy

Posted By: Gentleman
Subject: This Thing Is Driving Me Crazy
Date Posted: August 11, 2002 at 5:50 PM

Dodge Dakota 2002....Crimestopper CS2000
The door negative trigger was wired to the dome light circuit which has a fade off delay, this caused the alarm to chirp 3 times telling me there is a zone fault and also the delay was preventing the doors from locking because the cpu thought the door was open, other than that everything worked I found in the drivers kick panel a tan wire for the passsenger door trigger and a tan/red wire for the passenger door, these triggers are actually for the door ajar light they are - when doors are open and read nothing when doors are closed, thought I was on to something, used the diode method to wire the two to the alarm. now 30 sec after being armed the alarm goes off. Why ??????



Replies:

Posted By: cdaw
Date Posted: August 11, 2002 at 11:01 PM

I used a diode - and connected directly to the ajar light wire, behind my dash, this way  (for my car) the trunk is also picked up (along with all 4 doors) w/o needed an extra sensor or wires.

Before, The alrm would not sense the Trunk, and would go off when you closed it, due to the shock sensor. Now - I pop the trunk the alarm wont arm untill 30 seconds after I close it.

I'm using full active alarm./ locks /windows

JT 



-------------
JT



Posted By: Gentleman
Date Posted: August 12, 2002 at 5:11 AM
I used the diodes


Print Page | Close Window