hi im getting one of these next week im doing a remote start dei python 881xp any info on tech soft dei forums has no info yet any body done this im also adding window roll up 2 all 4 windows
-------------
I love bass
12 VOLTS CONSTANT... PINK/BLACK & RED.. IGNITION SWITCH HARNESS
IGNITION 1... DARK BLUE ... IGNITION SWITCH HARNESS
IGNITION 2... DARK GREEN/ RED... IGNITION SWITCH HARNESS
IGNITION 3... BLACK/ ORANGE... IGNITION SWITCH HARNESS
IGNITION 4... DARK GREEN... IGNITION SWITCH HARNESS
ACCESSORY... BLACK/ WHITE... IGNITION SWITCH HARNESS
STARTER... YELLOW... IGNITION SWITCH HARNESS
PARKING LIGHTS BLACK / YELLOW (+) AT SWITCH
PWR DOOR LOCK/UNLOCK (Single Wire System) WHITE/ GREEN ( - )820 Ohm
UNLOCK ( - ) 330 Ohm 14 Pin CONN. IN DRIVER KICK OR CTM
WINDOW UP D\ L BLUE ... P\ BRN/WHT D\ BLU/WHT ... P\ GRY/BLK
WIN DWN F/ WHITE ... F/ VIO/WHT R/ RED / BLK ... R/ GRN/WHT
BRAKE WHITE/ TAN ( + ) @ BRAKE SWITCH
FACTORY ALARM DISARM LT. GREEN/ ORANGE (-) CTM IN DRIVER KICK PANEL
FACTORY ANTI-THEFT TYPE TRANSPONDER (GRAY KEY ONLY)
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
04 is a new vehicle, with new wiring, I installed a starter into one a couple of weeks ago, here's the wiring:
12 VOLTS RED / blue + ignition harness
STARTER 1 pink/lt.blue + ignition harness
IGNITION 1 pink + ignition harness
IGNITION 2 pink/green + ignition harness
ACCESSORY 1 pink / YELLOW (x2) + ignition harness
Smaller pink / YELLOW may not be necesary for remote start
ACCESSORY 2 pink/tan + ignition harness
Required for remote start. Airbag light triggers if this wire is not energized during start
KEYSENSE violet/brown - ignition harness
POWER LOCK violet/green type h main harness, left of brake pedal
Lock requires ground through 330 ohm resistor. Must use relay.
POWER UNLOCK violet/green type h main harness, left of brake pedal
Unlock requires ground through 100 ohm resistor. Must use relay.
DISARM NO UNLOCK see disarm note black plug, left of brake pedal
FACTORY ALARM ARM lt GREEN/ orange type h black plug, left of brake pedal
Arm/Lock requires ground through 620 ohm resistor.Must use relay.
FACTORY ALARM DISARM same as arm type h black plug, left of brake pedal
Dirarm/Unlock requires ground through 1500 ohm resistor. Unlock is double pulse. Must use relay.
TACH not BROWN / white ac coil
Tach can be found at any of the ign coil packs. For example Blue wire at coil on driver's side.
ITEM NOTE INFOTECH #
Immobilizer Use DEI part number 555U.
Special Note Extra keys are worth around $156.00. The chip cannot be removed from the keyfob. If IP display says "key in fob is invalid" when remote starting then try placing the antena ring in a diffrent location -- not easy. To program a new key, use two originals and follow Chrysler key programming procedure wait for "security" to flash to end programing.
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta