Does anyone know about the TDS system in Toyota's? I am trying to intergrate a remote starter into my keyless entry system but need some info on it.
It is marked "main module part number 00016-30960-01"
Any help would be helpful.
-------------
Thanks,
Bill
Dont know about that but, here is a wiring diagram.
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | BLACK | IGNITION SWITCH HARNESS |
Ignition #1: | | BLACK/ RED | IGNITION SWITCH HARNESS |
Ignition #2: | | BLACK / YELLOW | IGNITION SWITCH HARNESS |
Ignition #3: | | N/A | |
Accessory: | | BLUE/RED | IGNITION SWITCH HARNESS |
Brake Light: | | GREEN / WHITE (+) | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | BLACK | AT IGNITER ON PASSENGER WHEELWELL * |
Parking Lights: | | GREEN (+) | # PIN GRAY CONN. AT FUSE BLOCK ** |
Headlights: | | RED / BLUE (-) | AT HEADLIGHT SWITCH |
OEM Alarm Disarm: | | N/A | IN SCHEAMTICS |
OEM Alarm Arm: | | N/A | NO OEM ALARM PRESENT |
Diesel Glow Plug: | | | |
Clutch Bypass Wire: | | | |
Notes: | | * BLACK Tach Wire Also Located In 26 Pin Connector Behind Glove Box. |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | WHITE/ RED & WHITE | IGNITION SWITCH HARNESS |
Starter Kill: | | BLACK | IGNITION SWITCH HARNESS |
Ignition +12 Volts: | | BLACK/ RED | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | BLACK/ WHITE (-) | 2 PIN GRAY CONN. AT FUSE BLOCK ** |
OEM Horn: | | GREEN/ RED (-) | STEERING COLUMN HARNESS |
Power Lock: | | RED / WHITE | # PIN CONN. IN DRIVER'S KICK *** |
Power Unlock: | | RED / YELLOW | # PIN CONN. IN DRIVER'S KICK *** |
Trunk Release: | | N/A | |
Alarm Input Wire: | | BLACK/ WHITE (-) | 2 PIN GRAY CONN. AT FUSE BLOCK ** |
Notes: | | ** Fuse Block Located In Driver Kick Panel. *** Child Safety Locks: RED / BLUE (-) In Same Connector As Door Lock Wires Above. See Note #209 - Toyota Child Safety Door Lock Diagram. |
toyota pickup factory alarm does not offer a trunk release output . if it was a car you could use a car start add on and delete the truck pop and use that signal to send to the carstart input wire
-------------
we need more info on your remote system
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt