2002 Toyota Tacome 4DR

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27186
Printed Date: May 20, 2025 at 7:46 PM

Topic: 2002 Toyota Tacome 4DR

Posted By: draasch
Subject: 2002 Toyota Tacome 4DR
Date Posted: February 25, 2004 at 8:45 AM

depends on how many outputs you have on the remote start unit.

Make:   Toyota
Model: Tacoma
Year:    2002
This Database Was Last Updated On:    6/9/2003
Index #: 7682

Alarm
Constant 12 volts WHITE/ RED AND WHITE IGNITION SWITCH HARNESS
Ignition 12 volts BLACK/ RED IGNITION SWITCH HARNESS
Starter BLACK IGNITION SWITCH HARNESS
Dome Light BLACK/ WHITE (-) 12 PIN CONN ON BACK OF FUSE BOX *
Trunk Pin Switch N/A
Parking Lamp GREEN (+) REAR BODY HARNESS, LOWER DRIVER KICK
Power Lock BLACK/ BLUE 12 PIN CONNECTOR IN #209
Power Unlock RED / YELLOW DRIVER KICK PANEL ** #240

* Also Found As BLACK/ WHITE (-) In 3 Pin Conn. High In Dr Kick Panel. * Fuse Box Located Behind Driver Dash. ** Child Safety Locks:GREEN/ BLACK In 12 Same Connector As Door Lock Unlock Wires. #209 - See Child Safety Door Lock Diagram. SEE TECH NOTE #240 - Toyota / Lexus Data Link Door Lock Circuit.

Remote Start
Tach Signal GREEN/ BLACK AT IGNITER OR DASH TACHOMETER *
Ignition #2 BLACK / YELLOW IGNITION SWITCH HARNESS **
Ignition #3 N/A
Accessory BLUE/RED IGNITION SWITCH HARNESS
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light GREEN / WHITE (+) AT SWITCH ABOVE BRAKE PEDEL (DKP)
Reverse Light RED / BLACK (+) AT SWITCH ON TRANSMISSION (DKP)
Rear Window Defrost N/A

* 2WD 4 Cylinder Engine and 6 Cylinder Engine Tach Wire Is Located At Igniter On Passenger Side Of Engine. 4WD 4 Cylinder Engine Tach Wire Is Located At Engine Control Module Located Behind Passenger Dash. On All Models, Tach Wire Can Also Be Found In 26 Pin Gray Connector Behind Passenger Dash. ** Key Warning Wire (LT GRN/RED At Stering Column) MUST See Ground In Order To Remote Start. Suggest Use Negative Ignition Output From Unit

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Replies:

Posted By: Scott35
Date Posted: February 25, 2004 at 3:30 PM

You don't need the blue/red, it will power your radio. Hook your wire for the blower back to the BLACK / YELLOW, your 2nd ignition.

-------------
Tacomacrew

Posted By: daniel2002p
Date Posted: February 25, 2004 at 3:56 PM

Bing0] wrote:

p>If the vehicle is started and the AC and Blower were left on, wouldn't they come on with remote start? If not, why?
Any advice prior to install would be appreciated. I am also interested in maybe adding an accessory to control but not sure what might be a good one. Any suggestions.

The reson they would not come on is because they are turned on by a wire other than the main ignition. That is why you have 2 ignitions and a accessory wire. they are all powered when you turn the key, but not all powered automatically when the rs is activated thouigh the main igniiton.

-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

Posted By: XMC SAM
Date Posted: February 26, 2004 at 1:12 AM

You can also use gray (-) for lock and purple (-) for unlock at the integrated control module( left side of steering column) right in front of the dash when you pull the lower dash down.

there are two purple wires,use the purple wire that is on the bottom row, this way you wont need to hook up the child safety locks. works all the time. You can locate it by hitting the lock/unlock switch and hearing for the clicking noise. It only has one harness in front

-------------