clifford override
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27220
Printed Date: June 09, 2024 at 11:18 AM
Topic: clifford override
Posted By: aboutsound
Subject: clifford override
Date Posted: February 25, 2004 at 4:47 PM
Hi,
I have a clifford concept 200 alarm that has had the remote lost while the vehicle was armed. I have 2 new remotes that I need to code to the unit, however I cannot disarm the alarm. I have tried the *,*, blank procedure on the plain veiw 2 switch but this does not work. I think the pin code has been changed (the alarm was in the car when it was purchased and the previous owners are uncontactable). Can anyone help me with disarming the alarm and tell me how to code the new remotes???
Thanks Kent
Replies:
Posted By: rubalex1
Date Posted: February 27, 2004 at 7:58 AM
if you don't have cliffnet wizard access. your only other way out is to send it back to clifford and have them reset the code back to default. *,*, blank
-------------
Ruben Giraldo
Atlanta GA.
Test twice, tap once!
Always double check your wires, and not only rely on what the schematics say.
|