Interior Motion Sensor placement
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27360
Printed Date: July 13, 2025 at 9:29 AM
Topic: Interior Motion Sensor placement
Posted By: NINsane18
Subject: Interior Motion Sensor placement
Date Posted: February 27, 2004 at 8:20 PM
Hey all, I have a 98 jeep grand cherokee. I am installing a microwave motion detector on a crimeguard 745i and it recommends placement in the center console. The only bad thing is there really is no good place for it there. I was thinking of mounting it on the upper temp/compass console on the roof. Would this affect performance pointing downward instead of up? I was going to try it but I have to extend the wiring in order to run it up the windshield pillars and to the overhead console. Thanks in advance!!
-------------
Tim-May!
Replies:
Posted By: bmf1000d
Date Posted: February 27, 2004 at 10:14 PM
You can install it in the center all you have to do is take out the center console. Just remove the 2 screws in the front of the console and then the 4 in the compartment. I placed mine by the ebrake cable and it works great
-------------
"Big" Mike
Double Take
Fremont, Ne
remember to check all your wires with a dmm not a test light!!
i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof
Posted By: NINsane18
Date Posted: February 28, 2004 at 6:53 AM
I know exactly where you are talking about. It is supposed to be nice out, so I am going to try and get it done today. Thanks for the response!
Tim
-------------
Tim-May!
|