remote start problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27363
Printed Date: May 15, 2024 at 12:00 PM

Topic: remote start problem

Posted By: skizza502
Subject: remote start problem
Date Posted: February 27, 2004 at 9:00 PM

I need help... I've completed installation of a mannix remote / start alarm combo, on a 1998 chevy tahoe. The problem that I believe I'm having is with my passlock system. I've been through about 3 or 4 DEI 555L's, and countless hours, and can't quite get it right. The remote start worked Twice, and now nothing? The alarm dose its part and tries to start, and even works in turbo, but passlock wont let it remote start. Any 1have any suggestions?

Replies:

Posted By: mo12v
Date Posted: February 27, 2004 at 9:50 PM

Assuming you have the RIGHT PASS 2 wires *(thin yellow) *(thin ORANGE / black)
And you have cut the yellow wire in half....attaching Yellow wire from 555L to yellow half that goes to Ignition switch......attaching BLACK / YELLOW to other half
And attaching Black wire from 555L to ORANGE / black
Red to + 12Volt Constant
Pink to Ignition 1 +
Make sure you have voltage upon Remote Start at Pink and Red

I would try puting key in ignition and turn to ON and try Remote Start
If it starts Double check your wiring again

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: Velocity Motors
Date Posted: February 27, 2004 at 10:34 PM

Try a different module for bypass. I would use PLDATA for this vehicle.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: skizza502
Date Posted: February 27, 2004 at 11:13 PM

tried remote starting with key in run position nothing happens

Posted By: Velocity Motors
Date Posted: February 27, 2004 at 11:18 PM

It's the bypass module & make sure that it is receiving a ground signal when remote starting. Test the ground out when running wire from the remote starter to ensure a proper (-) ground. Test the ground on the remote starter as well as this will affect the (-) output for this wire.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: skizza502
Date Posted: February 29, 2004 at 5:38 PM

Thanks for your help guys. I think the pldata will work best for me.