dome light mark anthony 10.4 flipdown
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27473
Printed Date: August 01, 2025 at 11:52 AM
Topic: dome light mark anthony 10.4 flipdown
Posted By: piper
Subject: dome light mark anthony 10.4 flipdown
Date Posted: February 29, 2004 at 9:06 PM
i installed a mark anthony 10.4 flipdown screen in a 02 ford explorer the screen show a perfect picture works great, but it has dome light in it i hook the lights up to the factory dome light acc 12v , door trigger and ground like instruction said but the light does not work, so i got another screen and the lights worked for a min. then quit now i can't get it to work and ideas would greatly be appreciated thanks
-------------
frankie marble
Replies:
Posted By: draasch
Date Posted: February 29, 2004 at 9:15 PM
which wires did you hook up to?????
------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: NowYaKnow
Date Posted: March 01, 2004 at 5:55 AM
A lot of time what I do when wiring in a domelight for the overhead is ONLY tap the trigger itself from the domelight. Tie the power and ground into your power and ground wire for the tv and run them to the ignition harness. I've been noticing a lot of the newer cars just don't have the power available to fire up the extra domelights on the domelight circuit itself. Doesn't blow a fuse or anything, just doesn't work. May want to give that a try. Good luck,
Mike
|