astra 777 in 1990 honda crxsi

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27543
Printed Date: August 15, 2025 at 2:39 AM

Topic: astra 777 in 1990 honda crxsi

Posted By: joecrx
Subject: astra 777 in 1990 honda crxsi
Date Posted: March 01, 2004 at 9:42 PM

im new to this so i got this new alarm system from asianwolf.com and i dont know where to start or how to or wich wire goes where. \

need help please

-------------
crx

Replies:

Posted By: profuse007
Date Posted: March 01, 2004 at 10:03 PM

lets start w/ the basic for keyless and security

1.power input: 12v pos and neg
|              12V|WHITE/ black        |+ |ign harness, f/b plug       |
2.keyless: unlock and lock wire
need to add door lock motors
3.security: siren and door trigger(s)
|     DOOR TRIGGER|GREEN/ red           |- |either running brd *2       |
*2 Harness running down and forward from dash indicator has door and hatch triggers.
4.parking light flash: the unit may have 2 polarity to choose from, neg or pos. you can manipulate from neg a pos w/ a simple relay setup, or vice versa.
| PARKING LIGHTS +|RED / green           |   |switch harness, f/box       |

check those wire b4 plug and chug and youll be fine.
pretty simple.

if you have remote start w/ this unit, repost the result above then well start w/ RStart.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: joecrx
Date Posted: March 01, 2004 at 10:22 PM

still confuse i want to put an astra 777 in my 1990 crx si 5 speed two door no power locks

no i dont have remote start wiht this unit

where do the wires from door trigger input go im so lost

-------------
crx

Posted By: Toru
Date Posted: March 01, 2004 at 11:06 PM

1988-91 Honda CRX Alarm Information

Study that chart. Connect each wire from the harness to the wire described in the chart.

For example, the door trigger. You need to connect the green wire on the harness (negative door trigger) to the green wire with a red stripe (GREEN/ red) found in the driver's running board (I think that means the plastic door sill cover - I don't own a CRX so I am not sure).