Print Page | Close Window

Auto door locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27823
Printed Date: May 15, 2025 at 5:58 PM


Topic: Auto door locks

Posted By: fjames623701
Subject: Auto door locks
Date Posted: March 06, 2004 at 10:50 AM

Hello all. I have just purchased a car secuirity system with remote start and keyless entry. I am a mechanic not a installer but I would like to tackle this one on my own. I have a 1990 Silvarado 3/4 ton 2WD. The locks are the 5 wire with a "ground at rest" set up. I have found on this site that I need 2 realys to make it work. However when I wire them up according to the diagram the regular door lock switch works but when I go to use the remote the lock will work then blow the fuse running the alarm. The alarm is the only device on the wire and it is a 20 AMP fuse running from the Bat. It seams to me like After the relay closes there is a very brief ground present. any help would be greatly apreciated. thanks is advance Jim




Replies:

Posted By: DBFORDTECH
Date Posted: March 06, 2004 at 1:09 PM

sounds like you have the switch side and the motor side reversed.




Posted By: DBFORDTECH
Date Posted: March 06, 2004 at 1:26 PM

Hi again, I re-read your problem and paid attention this time, please disregard my last post, I dont think its right




Posted By: draasch
Date Posted: March 06, 2004 at 7:09 PM
drop me your e-mail jim...........

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt





Print Page | Close Window