2000 caravan
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27923
Printed Date: May 20, 2024 at 1:23 PM
Topic: 2000 caravan
Posted By: murraymurray
Subject: 2000 caravan
Date Posted: March 07, 2004 at 9:06 PM
I am installing a remote starter keyless entry in a 2000 caravan with keyless entry,I want to use all on the remote starter remote when I am done. I have negative triggers from my remote starter to activate my door locks. My question is can i just tap into the relays or do i have to search for the white and green wires and use resistor. the owerner of this vehicle talked to the dealership and they say it has no factory alarm. Thank You Murray ------------- murraywatchel
Replies:
Posted By: smw82202
Date Posted: March 07, 2004 at 10:29 PM
i just had a problem with a 99 plymonth voyager, i used the white and green wire, it ask for a 1500 ohm on the lock side and a 250 ohm on the unlock side. (one wire controls the locks). when i hooked it up this way, nothing happened, it would lock the doors when i was unarming the alarm, quick fix, tap the white and green wire, put the 250 ohm(1/2 watt 5%) in place, then diode the green wire from the blue, attach both wires to the Resistor door locks will work the way they should. your white and green wire are under the fuse box, the left plug. take the cap off the plug, cut the tape back.
Posted By: serialthrlla
Date Posted: March 07, 2004 at 10:36 PM
you don't need a diode, you do have to use relays and the state resistor values will work fine. I do these vans very often
Posted By: murraymurray
Date Posted: March 08, 2004 at 7:29 PM
Using rlays can you tap to the same white green wire or do you have to find one for lock and one for unlock.
-------------
murraywatchel
Posted By: Velocity Motors
Date Posted: March 09, 2004 at 12:13 AM
left plug at bottom of fuse box under cover.Use relays and set up for negative trigger. Place a 4020 ohm resistor inline on the lock output, and a 665 ohm resistor inline on the unlock output. If you do not have a factory security system use a 1500 ohm for lock and a 250 ohm for unlock. Use this diagram for the relay configuration
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|