Viper 560xv

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=28107
Printed Date: July 26, 2025 at 3:33 AM

Topic: Viper 560xv

Posted By: dominos911
Subject: Viper 560xv
Date Posted: March 10, 2004 at 1:36 AM

I am installing a Viper 560xv in a 2000 Honda Accord. I have read the installation manual and was wondering how to install a trunk trigger input since there is none on this alarm. I have check the H1/6 wire already and it is labled multiplex input. Is there a way to either 1. Convert the mulitplex input to be a trunk trigger if so how would I go about doing that. 2. If not how would I install a trunk trigger. Thanks for the info in advance!

Replies:

Posted By: daniel2002p
Date Posted: March 10, 2004 at 10:19 AM

there should be a blue wire on the main harness, that is a instant trigger input. if your trunk is a negative trigger, then just run a wire from the trunk trigger to that wire, otherwise if not a negative trigger, use a relay to convert polarity. Hope this helps.

-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

Posted By: dominos911
Date Posted: March 11, 2004 at 9:00 AM

daniel2002p,

The blue wire is the mulitplex input and that is the only blue wire on the main harness.

Posted By: nava94
Date Posted: March 11, 2004 at 11:23 PM

dominos911 wrote:

I am installing a Viper 560xv in a 2000 Honda Accord. I have read the installation manual and was wondering how to install a trunk trigger input since there is none on this alarm. I have check the H1/6 wire already and it is labled multiplex input. Is there a way to either 1. Convert the mulitplex input to be a trunk trigger if so how would I go about doing that. 2. If not how would I install a trunk trigger. Thanks for the info in advance!

That H1/6 blue wire on the alarm harness will respond to a negative input. If your 2000 Accord is equipped with a trunk light you could use your trunk light as a trigger.The trunk light wire you could find it in the driver kick panel, make sure you use a Digital Multimeter when you test any wire. This wire will see 12volts when the trunk is closed and will see ground when the trunk is opened. The H1/6 wire can also be used for other DEI single stage sensors, along for hood and trunk.Good luck on you install.

Posted By: dominos911
Date Posted: March 12, 2004 at 12:03 AM

nava94,

Thanks for the info! That was very helpful.