02 CARAVAN REMOTE START

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=28278
Printed Date: July 15, 2025 at 2:59 PM

Topic: 02 CARAVAN REMOTE START

Posted By: IRNOTSLOW
Subject: 02 CARAVAN REMOTE START
Date Posted: March 12, 2004 at 9:54 PM

I am going to install an add on Remote Starter on a 2002 Dodge Caravan. The RS I am installing an add-on type unit. It uses either 1 or 2 negitive pulses to activate the stat sequence. I have a few questions: 1) i looked at the wiring for this van....

Factory Disarm

WHITE/ Dark Green

(665 Ohm) left Connector bottom of Fuse Panel

how do I wire this?

2) also I need the lock or unlock wire motor circut.... to trigger the starter

Door Lock	WHITE/ Dark Green (-)	BCM at Fuse Panel 1500 Ohm Resistor
Door Unlock	WHITE/ Dark Green (-)	White Connector B58 Connector 250 Ohm Resistor
Driver's Lock	Brown (+)	Junction Block
Driver's Unlock	Purple / YELLOW (+)	Junction Block

again how do i wire this?

3) Lastly Does this van have a factory anti-theft system? My research says no

thank you in advance

-------------
irnotslow

Replies:

Posted By: daniel2002p
Date Posted: March 14, 2004 at 9:09 AM

what kind of add on RS are you installing?? Stand alone that required 2 lock pulses to activate or a addon to a security system.

-------------
2005 Toyota Corolla S
1.8L VVT-i I-4
Always double check your wires with a DMM!!!
Do Not Use A Test Light!!!
MECP Certified Installer!
Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

Posted By: IRNOTSLOW
Date Posted: March 14, 2004 at 10:38 AM

it is a 20022 from www.autocommand.com (designtech). It is an addon. once all the required wiring is finished, you then need to find a neg pulse (lock or unlock) does not matter, My question is must I hook up the factory alarm disarm>>>

Factory Disarm

WHITE/ Dark Green

(665 Ohm) left Connector bottom of Fuse Panel

and how do wire that?

And two which wire do i use for the lock or unlock pulse, if need be i will use a reversing relay

Door Lock	WHITE/ Dark Green (-)	BCM at Fuse Panel 1500 Ohm Resistor
Door Unlock	WHITE/ Dark Green (-)	White Connector B58 Connector 250 Ohm Resistor
Driver's Lock	Brown (+)	Junction Block
Driver's Unlock	Purple / YELLOW (+)	Junction Block

I am assuming i can instal a reversing relay on the Brown or the PURPLE / Yellow wire, because it will unlock/lock thru the factory FOB.

-------------
irnotslow