installed a remote start w/ keyless in a 01 fullsize chevy van. all is well until the vehicle is started...
once remote started, there is absolutely no range. i disconnected the parking lights because i was told the dash lights give off an rf that may interfere with range. still no luck.
all the basics check out - what can be done to combat the interference from the vehicle?
that seem to be happening a lot on here....not sure what the fix is.....ill see what i can come up with....
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
IS it a converson van?
Was it a 2way pager RS?
IF nothing else move the antenna to see iof you can clear it up that way other wise you may have to shield the anntenna wire from the van.
-------------
"Big" Mike
Double Take
Fremont, Ne
remember to check all your wires with a dmm not a test light!!
i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof
if it has a factory alarm, there could be interference from that, you must change frequency. I know for a fact that can be an issue.
tom small wrote:
installed a remote start w/ keyless in a 01 fullsize chevy van. all is well until the vehicle is started...
once remote started, there is absolutely no range. i disconnected the parking lights because i was told the dash lights give off an rf that may interfere with range. still no luck.
all the basics check out - what can be done to combat the interference from the vehicle?
Well I have the Omega Max with the Echo 2 way remote. I have the same problem. The remote will almost not work at all after its running. My antenna is in the upper driver corner ofthe windshield.
we have tried letting the module hang down so that it is not near any vehicle components and also held the antenna, cord and all, out the driver's window and still no range while running...
p.s. it's a DEI 560 alarm/start (not a 2-way system)
any ideas would be appreciated
well that makes 2 chevy's .. lol