Remote entry system

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=28472
Printed Date: May 21, 2024 at 11:43 AM

Topic: Remote entry system

Posted By: marionlh
Subject: Remote entry system
Date Posted: March 16, 2004 at 11:11 AM

where might i find the wiring diagram for my OEM lock system on a 2004 Toyota Tundra Double Cab. I'm trying to find the correct wires to connect 2 actuator wires to make my A.R.E. hard tonneau cover lock work with my remote.

Replies:

Posted By: vaderfop
Date Posted: March 16, 2004 at 1:58 PM

Try this link...

Directfax doc 1070

if it doesnt work i'll see about emailing you the file...let me know

hope this helps

-------------
Remember check all your wires with a DMM!

Posted By: vaderfop
Date Posted: March 16, 2004 at 2:01 PM

almost forgot the wire colors are the same as the sequoia's

-------------
Remember check all your wires with a DMM!

Posted By: cbag1
Date Posted: March 16, 2004 at 2:15 PM

Power lock = WHITE/ green or GREEN/ black (-) driver kick or plug below fuses

Note: Meter these wires while turning the key in the driver door key cylinder.

Power unlock = blue/red (double pulse) (-) driver kick or plug below fuses

Note: Meter these wires while turning the key in the driver door key cylinder.

Can also use the passenger key cylinder wire for unlock, which only requires a single pulse. It is RED / yellow or RED / white in the passenger kick or the plug below the fuses.

Lock motor = blue/white (5wi) driver kick, door harness

Unlock motor = blue / YELLOW to BLACK / YELLOW ( 5wi) driver kick, door harness

good luck

Posted By: marionlh
Date Posted: March 17, 2004 at 9:52 AM

I have remote keyless entry on my 04 Tundra and the wiring colors are apparently different from what i'm hearing in the replies.