I plan on installing an Enforcer alarm in a '97 Civic h/b. The car has p/w, p/l, s/r, aftermarket stereo. The alarm is a few years old but never been used. Any tips, advice, diagrams that could possibly make this install easier will be greatly appreciated. I have experience as auto tech and electronics tech so no need to simplify "technical terms", just let her rip. Mahalo.
-------------
bt
Other than the wiring diagram (below) all you need to know is Honda's are one of the easiet alarm installs out there.
Honda
Civic
1996-2000
Remote Starter Wiring Colors and Notes
Function
Vehicle Color
Location
Start:
BLACK/ WHITE
IGNITION SWITCH HARNESS
Ignition #1:
BLACK / YELLOW
IGNITION SWITCH HARNESS
Ignition #2:
YELLOW
IGNITION SWITCH HARNESS
Ignition #3:
N/A
Accessory:
WHITE/ BLACK
IGNITION SWITCH HARNESS
Brake Light:
GREEN / WHITE (+)
AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:
BLUE
AT TACH TEST CONNECTOR *
Parking Lights:
RED / BLACK (+)
7 PIN GRAY CONN. AT FUSE BLOCK
Headlights:
RED (+)
AT HEADLIGHT SWITCH
OEM Alarm Disarm:
N/A
IN SCHEMATICS
OEM Alarm Arm:
N/A
NO OEM ALARM PRESENT
Diesel Glow Plug:
Clutch Bypass Wire:
Notes:
* Tach Test Connector Is A 2 Pin WHITE Connector Located On Driver Rear Of Engine Compartment.
--------------------------------------------------------------------------------
Honda
Civic
1996-2000
Alarm and Keyless Entry Wiring Colors and Notes
Function
Vehicle Color
Location
Constant +12 Volts:
WHITE
IGNITION SWITCH HARNESS **
Starter Kill:
BLACK/ WHITE
IGNITION SWITCH HARNESS
Ignition +12 Volts:
BLACK / YELLOW
IGNITION SWITCH HARNESS
Dome Lights/Superv:
L GREEN/ RED (-)
# PIN GRAY CONN. IN DR. KICK PANEL
OEM Horn:
BLUE (-)
STEERING COLUMN HARNESS
Power Lock:
GREEN / WHITE
# PIN BLUE CONNECTOR
Power Unlock:
GREEN/ ORANGE
TO LEFT OF FUSE BLOCK ***
Trunk Release:
N/A
Alarm Input Wire:
L GREEN/ RED (-)
# PIN GRAY CONN. IN DR. KICK PANEL
Notes:
** WHITE Wire Changes To WHITE/ BLACK At Base Of Steering Column. *** See Note #201 - Negative Pulse Door Lock Diagram.
I'm installing one on my 97 civic also. But I cant find the parking lights wire to save my life. If you find it, maybe you could tell me exactly where its at.
if you look at your fuse box there will be some male blade terminal plugs with no plugs in them (i think there are 3), one of those is the parking lights just test the terminal with a DMM for 12v with the parking lights on then just put a female spade connector on the parking light wire and plug it into that spot on the fuse box and that should be it.