Print Page | Close Window

rsx 3.5 trunk pin ?’s

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=28861
Printed Date: May 15, 2024 at 12:15 AM


Topic: rsx 3.5 trunk pin ?’s

Posted By: DUKE70301
Subject: rsx 3.5 trunk pin ?’s
Date Posted: March 22, 2004 at 7:26 PM

The blue wire on the harness is connected to the pink and black wire...and when you set off the trunk it show the hood on the lcd....and the hood pin is the gray wire when the hood is open it also shows the hood on the lcd.....any  feed back apprieciated




Replies:

Posted By: Teamrf
Date Posted: March 22, 2004 at 7:40 PM
The blue wire is an instant trigger wire. That should be hooked up to your trunk pin switch.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.




Posted By: DUKE70301
Date Posted: March 22, 2004 at 9:05 PM

Thats how i have it an it shows that the hood when the trunk is open





Posted By: sroth140
Date Posted: March 22, 2004 at 10:31 PM

as long as the blue wire in the main harness is getting a (-) trigger it should show tunk.  try arming the alarm and touching the blue wire to ground and see what it triggers.  then on then remote start harness (5-pin connector, starting with blue/white and ending with BLACK/ white) take the grey wire and try touching that right to ground.

if any of those fail to report to the remote properly, check the LED light and see if that is reporting the right zone.  if the LED is wrong too, the brain isnt getting something triggered right.



-------------
MECP certified installer




Posted By: nava94
Date Posted: March 22, 2004 at 10:36 PM
What kind of alarm did you install?




Posted By: nava94
Date Posted: March 22, 2004 at 10:44 PM
It sounds the set up is okay you should try and program your LCD remote. The DEI LCD remotes you have to press all four buttons to enter the program features of the remote, from here you just follow the instruction in the manual to set up the trunk and hood icons.




Posted By: profuse007
Date Posted: March 23, 2004 at 2:57 AM
i would second that idea of Nava94, i know its something like thats on the previous generation.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).





Print Page | Close Window