94 Honda Passport car security
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=28899
Printed Date: July 27, 2025 at 1:59 AM
Topic: 94 Honda Passport car security
Posted By: prieur
Subject: 94 Honda Passport car security
Date Posted: March 23, 2004 at 9:38 AM
Can anyone email me the wiring schematics for a 94 Honda Passport in order to install a remote starter and car alarm.
thanks
Replies:
Posted By: Big Dog
Date Posted: March 23, 2004 at 9:41 AM
Try this:
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|black |+ |ignition harness |
| STARTER|wht/blu or blk/wht |+ |ignition harness |
| SECOND STARTER|blk/red or green |+ |ignition harness |
| IGNITION|BLACK / YELLOW |+ |ignition harness |
| ACCESSORY|blue |+ |ignition harness |
| POWER LOCK|add actuator | |in drivers door |
| POWER UNLOCK| | | |
| PARKING LIGHTS +|GREEN/ red | |by left front speaker |
| HEADLIGHTS|RED / blue |- |at light switch |
| DOOR TRIGGER|RED / green |- |2 pin plug by LF spkr. |
| TRUNK/HATCH PIN|lt. green |- |drivers kick or *2 |
|TRNK/HTCH RELEASE|RED / blue |+ |at switch |
| TACHOMETER|blue, BLACK/ red | |at coil, coil pack |
| BRAKE WIRE|red |+ |brake pedal switch |
| HORN TRIGGER|GREEN/ red *3 |- |steering column |
| WIPERS|blue |+ |at switch |
| LF WINDOW UP/DN|RED / yel - grn/yel |A |drivers door switch |
| RF WINDOW UP/DN|blu/wht - blu/blk *1|A |drivers door switch |
| LR WINDOW UP/DN|RED / blu - grn/blu *1|A |drivers door switch |
| RR WINDOW UP/DN|RED / blk - grn/blk *1|A |drivers door switch |
Notes:
*1 The window wires change color in the drivers kick. The R.F. window is grn/red for up and RED / yel for down. The L.R. window is grn/orn for up and RED / blk for down. The R.R. window is grn/blu for up and red for down. *2 behind left rear side panel at the rear wiper diode. *3 High-current ground. Use a relay when interfacing with this circuit.
|