i have done a search on this and could not find the answer
genaric pwm installed and i get a 2 second run on the windows then they stop. i do not have power door locks so i was informed in using the lock side to do a up only.
what else can i try the module is for 2 windows the ogange wire was for the lock - input and it has a pink for accesory. soould that be used?
thanks for any help anyone can give me
It sounds like you may not be using the proper trigger or setting. If you are using it as a stand alone without an alarm, you may need to use a latching relay to provide the (-) current to make them travel the full distance.
If you are using an alarm accessory output trigger,consider using a "ground when armed output", like what you would use to trigger a starter kill relay, or increase the pulsed output to 3 seconds, if possible. I use a "ground when armed output" on my window modules and they work great.
Keeping in mind, this set up is specific to window roll up when arming an alarm. If doing a dual window module that will control say rolling/crack one or both, you will need to use one of the alarm's accessory (-)outputs and or, converting the output to a negative trigger with a relay if using a (+) output trigger. This may sound alittle confusing but most of the modules operate off of a negative input.
The pink wire you mentioned is one I have yet to use, but can control another accessory, if desired.
I hope this is of some assistance.[8D)
-------------
elrock-SS