96 cirrus doorlocks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=29207
Printed Date: November 03, 2025 at 7:48 PM

Topic: 96 cirrus doorlocks

Posted By: sterjs
Subject: 96 cirrus doorlocks
Date Posted: March 28, 2004 at 8:51 PM

I will be installing the power door locks in 96 Cirrus soon, but the wiring diagram table only shows it will unlock with 1.5 ohms. But what is the resistance to lock?

Also, will I need to use relays? The alarm manual is not very specific on whether I need them or not. I've only used relays for 3 wire systems. This is on an Excalibur ATV-1000 alarm.

Thanks,

Sergio

-------------
1993 Jeep ZJ Laredo
2000 Ford Taurus SE

Replies:

Posted By: draasch
Date Posted: March 28, 2004 at 8:59 PM

Power Lock SINGLE WIRE SYSTEM BROWN 16 PIN CONNECTOR #217
Power Unlock WHITE/ GREEN IN DR. KICK PANEL ***

*** Single Wire Door Lock System, WHITE/ GREEN Wire Requires A 12 VDC (+) Pulse Thru A 620 Ohm Resistor To Lock And A 12 VDC (+) Pulse Thru A 2.7K Ohm Resistor To Unlock.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: sterjs
Date Posted: March 28, 2004 at 11:30 PM

Thanks for the quick reply David!

Posted By: draasch
Date Posted: March 28, 2004 at 11:35 PM

anytime

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Print Page | Close Window