Bit size for LED

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=29216
Printed Date: May 28, 2024 at 1:54 PM

Topic: Bit size for LED

Posted By: mrjazz
Subject: Bit size for LED
Date Posted: March 28, 2004 at 10:12 PM

Just need to know the size drill bit to use to make the hole for the LED light. hey David could you log onto to AIM

Replies:

Posted By: FullForce
Date Posted: March 28, 2004 at 10:42 PM

5/16

Posted By: auex
Date Posted: March 28, 2004 at 10:44 PM

Depends on brand.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Posted By: sroth140
Date Posted: March 29, 2004 at 12:04 AM

9/32 or 1/4 go buy a stepbit.

it still makes a difference on brand and if you do a flush mount or surface mount.

-------------
MECP certified installer

Posted By: draasch
Date Posted: March 29, 2004 at 12:07 AM

a step bit is the way to go....or a reemer...

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Print Page | Close Window