I have a problem with a Legend that has the tilt feature control. Problem is it won't work on with the "auto" turned on. All the the buttons work fine all of the time but the streering wheel won't go up and in when the key gets pulled out of the ignition. It works with the driver memory on the door memory buttons. It looks as if the key sense works fine, the dome lights turn on when the key is pulled out and it chirps when the key is in with the door open. It's looks as if the control box is all of the way above the dash but why does it say to interupt the BLACK/ bed wire going to the rear of the car?)(not interupted BTW) I have checked the switch itself and am certain the the switch is perfect. The owner claimes it was working fine before the remote start. I have checked and re-checked every connection, I even unplugged every thing to stock and still no luck. All the fuses were checked.......
Any help/ideas?
so what is it thatyou are have problems with? is it the tilt not working? or the controls on the steering wheel??
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
The problem is the "auto" feature doesn't work on the tilt steering. It's supposed to go up and in when the key is out of the cylinder.
did you tap anything at all off the keysense wire? if so you may have to diode isolate them
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
No I haven't. All other features of the key sense work fine like the dome lites. The dealer stated that it's a common problem with remote starts and the tilt feature. I think this kid(owner) is BSing me. I don't know if it worked or not before it was installed. Hmm...