I have a 4dr Neon with OE Alarm and Keyless Entry. Does anyone have the wiring diagram for all connections (alarm/remote start). Also any helpful info on disabling or integrating factory alarm/keyless entry system. installing a DEI Valiant 552. Thanks
ITEM | WIRE COLOR |POL| WIRE LOCATION
12V pink/black |+ | igntion harness
STARTER yellow |+ | gnition harness
IGNITION blue |+ | ignition harness ACCESSORY BLACK/ orange |+ | ignition harness
SECOND ACCESSORY BLACK/ white |+ | ignition harness
POWER LOCK lt. green |*1 | drivers door harness
POWER UNLOCK same wire
PARKING LIGHTS BLACK / YELLOW |+ | steering column
DOOR TRIGGER yellow *2 | - | drivers kick panel
DOME SUPERVISION |use door trigger
TRUNK/HATCH PIN tan/black | - | trunk light
FCTRY ALARM ARM arms with lock
FCTRY ALRM DISARM disarms with unlock |
TACHOMETER BLACK/ gray ignition coil
BRAKE WIRE WHITE/ tan |+ | brake switch
HORN TRIGGER BLACK/ red | - | steering column
Notes:
NOTE: All models with a gray ignition key require the use of DEI part number 555C or 555U when adding a remote start. *1 Relays are required for both lock and unlock. Lock is negative trigger thru a 1K ohm resistor, unlock is negative thru a 250 ohm resistor. If vehicle has factory alarm, use negative trigger thru a 2.7K ohm resistor for arm/lock, and negative thru a 7.5K ohm resistor for disarm/unlock, use double pulse for unlock. *2 To avoid the dome light delay use tan in the drivers kick for the drivers door and blue/orange in the passengers kick for the passengers door. Both wires are negative trigger and must be diode isolated. *3 The keyless entry module is located in the center top of the dash. Remove the dash top to access.
For alternative bypass module with integrated doorlock/alarm. Check this site:
https://www.12voltshop.com/cadetails.asp?prodid=CHDL-3-PK&cat=22&path=1,22
goodluck
Thank you, for the info. However I do have another question. This car has a grey key (I suppose its transponder type?). This lists 555u or 555c to bypass for remote start. do you know the omega equivilant and are relays needed with the factory alarm system for keyless entry? Any other useful info to this model would be greatly appreciated. Thanks,