Please see my previous post on 2202 dodge ram rke
Thanks for the input I still am unable to find the correct wire for the drivers doorlock only, can anyone point me in the right direction. Am i going to have to open it up in the door panel or will it pass back into thru drivers compartment? The wire I think it is, is blue and it comes off the white conn to the left of the steering column, this is also the location of the WHITE/ green and the lt GREEN/ orange disarm wire, but I see 2 wires that appear to have reversal when the unlock button is pressed,They are blue and tan/orange
not sure?
Thanks
The notes below this diagram should help you out.
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | YELLOW | IGNITION SWITCH HARNESS |
Ignition #1: | | BLUE (16 AWG) | IGNITION SWITCH HARNESS |
Ignition #2: | | RED | IGNITION SWITCH HARNESS |
Ignition #3: | | GREEN & ORANGE (2 WIRES) | IGNITION SWITCH HARNESS |
Accessory: | | BLACK/ WHITE & BLUE (2 WIRES) | IGNITION SWITCH HARNESS |
Brake Light: | | WHITE/ TAN | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | TAN/RED | AT IGNITION COIL |
Parking Lights: | | PURPLE / YELLOW | HEADLIGHT SWITCH* |
Headlights: | | PURPLE / YELLOW | HEADLIGHT SWITCH * |
OEM Alarm Disarm: | | LT. GREEN/ ORANGE ***** | HARNESS COMING IN FROM DRIVER'S DOOR |
OEM Alarm Arm: | | | |
Diesel Glow Plug: | | ORANGE / Black | Powertrain Control Module*** |
Clutch Bypass Wire: | | | |
Notes: | | * This Is A Single Wire System. Parking Lights Need To See A Ground (-) Through A 330 Ohm Resistor. Headlights Need To See A Ground (-) Through A 700 Ohm Resistor. ** Diesel Vehicles - ORANGE / Black Wait to Start; Tach Wire Is Gray/Black. Both Wires Are Located In A Black Connector Center Top Of Fire Wall. There Are Two Black Connectors, The Correct One Does Not Have A White Insert. *** Tach can also be located at pin 74 behind instrument cluster. |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | PINK/BLACK | IGNITION SWITCH HARNESS |
Starter Kill: | | YELLOW | IGNITION SWITCH HARNESS |
Ignition +12 Volts: | | BLUE (16 AWG) | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | SEE NOTE *** | |
OEM Horn: | | BLACK/ RED (-) | STEERING COLUMN HARNESS |
Power Lock: | | WHITE/ GREEN | DRIVER'S KICK PANEL **** |
Power Unlock: | | WHITE/ GREEN | DRIVER'S KICK PANEL **** |
Trunk Release: | | N/A | |
Alarm Input Wire: | | SEE NOTE *** | |
Notes: | | *** Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. **** Single Wire Door Lock System See Note #211. Lock Requires A Ground (-) Pulse Through A 867 Ohm Resistor. Unlock Requires A Ground (-) Pulse Through A 364 Ohm Resistor. Diode Isolate One Of The Wires. ***** Requires A Negative Pulse Through A 1.5 K-Ohm Resistor. |
where u getting the blue wire from???
that truck has a single wire system....you may have to go into the drivers door....
have you thought about using a CHDL3A???
https://www.bypasskit.com/wizard.asp-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Blue is the driver door on the 2002 it should show 12 volts when you use the factory remote
-------------
Joe O'Byrne
Owner / Installer