Print Page | Close Window

98 Chevy Z 28 OEM Disarm Alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30096
Printed Date: October 31, 2024 at 5:57 PM


Topic: 98 Chevy Z 28 OEM Disarm Alarm

Posted By: golfnut64
Subject: 98 Chevy Z 28 OEM Disarm Alarm
Date Posted: April 10, 2004 at 5:53 AM

Hi guys still looking for a way to disarm the factory alarm system all of the wire color charts say this wire is not avalible for hooking up remote start Please help Thanks

-------------
Lloyd



Replies:

Posted By: draasch
Date Posted: April 10, 2004 at 6:15 AM
OEM Alarm Arm N/A NO OEM ALARM
OEM Alarm Disarm N/A PRESENT IN SCHEMATICS

are you sure you have one???

see if this helps any:

Power Lock RED / BLACK AT BODY CONTROL #228
Power Unlock ORG/BLK & GRY/BLK MODULE *

* Body Control Module (BCM) Is Located Behind The Passenger Dash. Please Note That There Are Two GRAY/BLACK Wires Located At The BCM. The Correct GRAY/BLACK Wire Is Located In A 32 Pin BLUE Connector And Will Show A (-) Ground When The Driver Door Is Opened. #228 - See Camaro/Firebird Door Lock Diagram.

https://wiringinstructions.com/228.htm

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt





Posted By: Velocity Motors
Date Posted: April 10, 2004 at 11:29 AM
I have seen alot of information pertaining to Chevy Cavalier's or Pontiac Sunfire's that apparently do not have the OEM alarm, but when it comes down to looking at the vehicle, it DOES have it. In most cases the OEM alarm doesn't have a disarm wire and doesn't disarm when the ignition is powered up. The only way to disarm the system is through the OEM remote FOB control.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: kgerry
Date Posted: April 10, 2004 at 2:33 PM
whats your email address? i will email you the security bypass info.....

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979




Posted By: Velocity Motors
Date Posted: April 10, 2004 at 5:15 PM
Here is a diagram for the vehicle if the OEM disarm DOES activate when it sees a voltage on the ignition wire.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: golfnut64
Date Posted: April 10, 2004 at 5:43 PM
Thanks for all the info E mail is slbor@comcast.net

-------------
Lloyd





Print Page | Close Window