ALARM/DOOR LOCK TRIGGER

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=3018
Printed Date: August 22, 2025 at 3:33 AM

Topic: ALARM/DOOR LOCK TRIGGER

Posted By: pat miller
Subject: ALARM/DOOR LOCK TRIGGER
Date Posted: August 23, 2002 at 2:04 PM

I have a Crimeguard CS9900 alarm installed and would like to also install an aftermarket power door lock system and operate with the alarm remote. This alarm does not have a door lock output trigger, but does have a starter disable relay output that is open when disarmed and grounded when armed. Any suggestions on how to convert this to a - or + pulse to use for a door lock trigger?

Thanks for your help.

Replies:

Posted By: oldboy
Date Posted: August 25, 2002 at 6:20 AM

Pat, DEI do sell a module called a 452T module which is a pulse generator. It uses the ground when armed output and converts it to either a positive or a negative trigger. If you intend to run a solenoid off this, you would then also need to use a pair of relays or a DEI 451M module. Good Luck

Posted By: pat miller
Date Posted: August 26, 2002 at 1:39 PM

This is exactly what I need. I just ordered one.

Thanks for the help,

--pat

Print Page | Close Window