Print Page | Close Window

Alarm trigger

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30223
Printed Date: July 05, 2025 at 11:26 PM


Topic: Alarm trigger

Posted By: Am3rikaz_m0st_W
Subject: Alarm trigger
Date Posted: April 12, 2004 at 7:16 AM

ok ive found the negative trigger on the vw golf 2002 its the BROWN / white wire in the drivers kick panel....(i think)...neway i was jus wondering if i can tap direct into it or do i have to put a diode in it or sonething?? thanks hellpppp:D



Replies:

Posted By: draasch
Date Posted: April 12, 2004 at 7:54 AM
here is what i have...the info i have are for cars that are here in the states...:

Make:   Volkswagen
Model: Golf
Year:    2002

Alarm
Constant 12 volts RED IGNITION SWITCH HARNESS
Ignition 12 volts BLACK IGNITION SWITCH HARNESS
Starter RED / GRAY IGNITION SWITCH HARNESS
Dome Light BLUE/GRAY (-) AT CONVENIENCE MODULE
Trunk Pin Switch BRN/BLU (-) AT LIGHT IN HATCH AREA
Parking Lamp GRY/RED & GRY/BLK (+) DRIVER'S KICK PANEL *
Power Lock YEL/BLU IN DRIVER'S #202
Power Unlock GRN/RED DOOR

* Diode isolation is Needed, Cathode Side (Band) Faces OME Wires. # See Positive Pulse Door Lock Diagram.


if you use a meter and the wire that you have shows as the dome light wire, then yes you can tap right into it.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt





Print Page | Close Window